No dies are included with the XL650.

Machine pictured shows available options. These are not included with the base machine. 

Electric case feeder (Stock#s 21079-82)automatically feeds cases right side up into the case feed tube, stops and start automatically to keep the tube filled.

Powder check die(Stock#21044) - a sensor that goes down into each case to monitor the level of powder in it. In the event of a significant error in powder charge, either high or low, it sounds an audible alarm.

Roller handle available in plastic(stock#22183) or aluminum(Stock#17950) grip, reduces fatigue, more comfortable to use for extended reloading sessions.

Strong mount(Stock#22052) - if your bench is either too low for comfortable use, or you need to access drawers underneath , the strong mount elevates the entire machine above your bench top. Raises height of the 650 to 38 1/2" without the optional electric casefeeder, to 44 1/2" with the electric casefeeder installed

Bullet Tray(Stock#22214)-Only usable with the strong mount, the bullet tray elevates the bullets to the level of the shellplate for easier reach.

Low powder alarm(Stock#16306) - warns you both audibly and visibly when powder level in the measure gets low.

Extra small bar(Stock#20780) throws down to about .5 grain

Magnum bar(Stock#21353) throws up to 73 grains of extruded and 82 grains of ball/spherical powder.

Belted Magnum Powder System(Stock#97126)- Throws over 110 grains of powder, Comes with the oversize powder die needed for calibers too large in diameter to fit in the standard powder die.